Pumps Types - Types of Pump - Classification of Pumps - Different Types of Pump — Transcript
Full transcript
- 0:07A pump is a device that moves liquids or gases, by mechanical action.
- 0:13All pumps have an inlet, a casing, and an outlet.
- 0:18During operation liquid enters the pump through the inlet located here, this side of the pump
- 0:23is also called the suction side.
- 0:25The pressure of the liquid is lowest at this point.
- 0:29The purpose of the pumps casing is to contain the liquid inside the pump during operation.
- 0:34The casing houses all of the pumps internal parts.
- 0:39The liquid leaves the pump through the outlet.
- 0:42This side of the pump is also called the discharge side.
- 0:45the pressure of the liquid is highest at this point.
- 0:50Inside the pump there is a component that physically moves the liquid through the pump.
- 0:55the type of component that's used determines the type of pump.
- 0:59Basically pumps can be grouped into two general categories, Positive Displacement Pump and
- 1:05Dynamic Pump.
- 1:07A positive displacement pump makes a fluid move by trapping a fixed amount of the fluid
- 1:12and forcing or displacing that trapped volume into a discharge pipe or discharge system.
- 1:19Some positive displacement pumps use an expanding cavity on the suction side and a decreasing
- 1:25cavity on the discharge side.
- 1:27Dynamic pumps impart velocity and pressure to the fluid as it moves past or through the
- 1:32pump impeller and, subsequently, convert some of that velocity into additional pressure.
- 1:38It is also called Kinetic pumps.
- 1:41These pumps operate by developing a high liquid velocity and converting the velocity to pressure
- 1:46in a diffusing flow passage.
- 1:51Types of Positive Displacement Pump: A positive displacement pump can be further
- 1:56classified according to the mechanism used to move the fluid.
- 2:01There are three types.
- 2:02Rotary-type positive displacement.
- 2:04Reciprocating-type positive displacement.
- 2:07Linear-type positive displacement.
- 2:10Rotary-Type Positive Displacement Pump.
- 2:13The nature of Rotary pump requires very close clearances between the rotating pump and the
- 2:19outer edge, making it rotate at a slow, steady speed.
- 2:23If rotary pumps are operated at high speeds, the fluids cause erosion, which eventually
- 2:29causes enlarged clearances that liquid can pass through, which reduces efficiency.
- 2:35Rotary positive displacement pumps fall into three main types:
- 2:40Gear pumps: A gear pumps are simple type of rotary pump
- 2:44where the liquid is pushed between two gears.
- 2:47Screw pumps: Screw pumps are the shape of the internals
- 2:50of this pump is usually two screws turning against each other to pump the liquid.
- 2:57Rotary vane pumps: This pumps are similar to scroll compressors;
- 3:02these have a cylindrical rotor encased in a similarly shaped housing.
- 3:07As the rotor orbits, the vanes trap fluid between the rotor and the casing, drawing
- 3:12the fluid through the pump.
- 3:14Reciprocating-type positive displacement Pump.
- 3:19Reciprocating pumps move the fluid using one or more oscillating pistons, plungers, or
- 3:24membranes (diaphragms), while valves restrict fluid motion to the desired direction.
- 3:30In order for suction to take place, the pump must first pull the plunger in an outward
- 3:35motion to decrease pressure in the chamber.
- 3:38Once the plunger pushes back, it will increase the pressure chamber and the inward pressure
- 3:43of the plunger will then open the discharge valve and release the fluid into the delivery
- 3:48pipe at a high velocity.
- 3:51Typical reciprocating pumps are: Plunger pumps:
- 3:55A reciprocating plunger pushes the fluid through one or two open valves, closed by suction
- 4:00on the way back.
- 4:02Diaphragm pumps: Similar to plunger pumps, where the plunger
- 4:09pressurizes hydraulic oil which is used to flex a diaphragm in the pumping cylinder.
- 4:16Diaphragm valves are used to pump hazardous and toxic fluids.
- 4:21Piston pumps: Displacement pumps usually simple devices
- 4:26for pumping small amounts of liquid or gel manually.
- 4:30The common hand soap dispenser is such a pump.
- 4:35Dynamic pumps are one category of pumps under which there are several classes, two of which
- 4:40are: centrifugal pumps and special pumps.
- 4:44Centrifugal Pumps.
- 4:46A centrifugal pump is a rotating machine in which flow and pressure are generated dynamically.
- 4:52The energy changes occur by virtue of two main parts of the pump, the impeller and the
- 4:58volute or casing.
- 5:00The function of the casing is to collect the liquid discharged by the impeller and to convert
- 5:06some of the kinetic (velocity) energy into pressure energy.
- 5:11Centrifugal pumps are subdivided into several categories:
- 5:15Axial Flow Pumps:
- 5:17Axial Flow Pumps are high flow, low pressure pumps which lift fluid in a direction parallel
- 5:23to the impeller shaft.
- 5:25Mixed Flow Pumps:
- 5:27Mixed Flow Pumps are medium flow, medium pressure pumps which push fluid out away from the pump
- 5:33shaft at an angle greater than 90.
- 5:37Radial Flow Pumps:
- 5:38Radial Flow Pumps are high pressure, low flow pumps which accelerate fluid along the impeller
- 5:44blades perpendicular to the shaft.
- 5:48Special Pumps: There are also a number of special types of
- 5:51dynamic pumps which are defined by certain characteristics.
- 5:56Cantilever Pumps: Cantilever Pumps are centrifugal pumps with
- 6:00long cantilever design used in sump pump applications.
- 6:05Jet Pumps: Jet Pumps are kinetic pumps with an ejector
- 6:09attached at the discharge outlet, utilizing the Venturi effect and motive fluid to generate
- 6:15pumping pressure.
- 6:16Turbine Pumps:
- 6:18Turbine Pumps are centrifugal pumps that use pressure in combination with a rotary mechanism
- 6:24with numerous small impellers and vanes to transfer energy to a fluid.
- 6:29Dear sir, Thanks for watching the video.
- 6:32More update please subscribes our channel Learning Engineering, and get notification
- 6:37to press the bell icon.
About this transcript
This page contains the full transcript of Pumps Types - Types of Pump - Classification of Pumps - Different Types of Pump by Learning Engineering, generated from the public captions YouTube serves with the video. The transcript has 885 words across 91 segments, with the original timestamps preserved so you can click any line to jump to that moment in the embedded player.
What you can do with it
Use the transcript to take notes, quote the speaker, build a study guide, generate a summary with ChatGPT or Claude via the YouTube Summary tool, or export it as a timed subtitle file with YouTube to SRT. You can also re-open it in the transcriber to choose a caption track available on the video.
Free YouTube transcript tool
YouTube2Text is a free YouTube transcript generator — no signup, no daily limit. Paste any YouTube link and get the full transcript instantly, with timestamps, click-to-jump, caption language selection, AI prompts for ChatGPT, Claude, and Gemini, and exports to TXT, SRT, VTT, or Markdown.